Tig Installation; Tig Torch Connection - Sol Welding CRONOS Serie Manual De Instrucciones

Instruction Manual
8.

TIG INSTALLATION

NOTE: numbers shown below are referring to Fig. 1 chapter 6
COMMANDS DESCRIPTION to Page 4.
8.1

TIG TORCH CONNECTION

1. Connect the power cable of the Torch
to socket (12).
Negative polarity (-).
2. Install the GAS regulator on the tank.
3. Connect the GAS hose to the pressure
regulator.
4. Connect the other end of the GAS hose
to the TIG torch.
5. Open the GAS regulator.
6. Set the correct flow of GAS between
5 and 8 litres/min.
8.2 CONNECTION TO BASE MATERIAL
1. Connect the ground cable to socket
(11). Positive polarity (+).
2. Secure the other end of the ground
cable to the base material, making sure
that a good electrical contact is
established.
CRONOS SERIES
GB
GB
7