Starting And Standard Regulation; Remote Control Usage; Key Use - Sol Welding QUAD Serie Manual De Instrucciones

Instruction Manual
10.

STARTING AND STANDARD REGULATION

NOTE: numbers shown below are referring to Fig. 1-2-3-4-5-6 of
chapter 6 COMMANDS DESCRIPTION to page 7.
1. Set switch (2) "HF ON/OFF", into position "0" or "1"
depending on the kind of TIG start you desire Lift-arc
or HF.
2. Turn ON the generator by turning the switch (11) in posi-
tion "1".
Warning! All the settings and the regulations are memorized
after the last welding is finished. They are shown once the
generator is restarted (including the number of programme
selected). In order to go back to the default setting, select
another programme and return to the one in use. In order to
memorize the new settings the memorizing programme pro-
cedure should be followed (See. Chap. 13 to page 39).
10.1 REMOTE CONTROL INSTALLATION
I n p u t Ty p e o f
R e m o t e C o n t r o l
FOOT CONTROL
REMOTE CONTROL
GB
18
.
1. After switching ON the
machine if a remote control
is connected to socket (6),
the digital display (43) will
show the kind of controls
that can be used.
2. If a FOOT remote control
is used, press push botton
(49 Up).
3. If a MANUAL remote con-
trol is used, press push bot-
ton (49 Down).
NOTE: by using the FOOT Remote control, the generator automa-
tically select the torch switch cycle 2 times (see Par. 10.4 to page
20) and the PREGAS time changes to 0.
10.2

KEY USE

By placing the key in this position the operator can
make all the possible adjustments.
Example: Modify the balance selected from the synergy
in mode TIG AC
By placing the key in this position the operator is only
able to:
a) regulate the welding current.
b) select the COLD WIRE cycle.
c) select the ELECTRODE mode.
d) change the JOBS.
QUAD AC/DC SERIES
1. The key located in the
frontal panel allows the
operator to adapt the adjus-
tments.