Publicidad
Idiomas disponibles
Idiomas disponibles
1. Attach (4) panel clips to the radio trim
panel using (4) panel clips supplied.
(Figure A)
2. Mount the pocket to the radio brackets
with (4) #8 x 3/8" truss-head Phillips
screws supplied. (Figure B)
3. Mount the bracket/pocket assembly
to the radio housing with (4) #8 x 3/8"
Pan-head Phillips screws supplied.
(Figure C)
6
KIT ASSEMBLY
(Figure A)
(Figure B)
4. Slide the radio into the completed
assembly and secure with screws
supplied with the radio. (Figure D)
5. Attach the A/C vents to the radio housing
using the factory hardware.
6. Attach the hazard switch to the radio
housing using (2) #8 x 1/2" Truss-head
Phillips screws supplied.
7. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
8. Reassemble the dash in reverse order of
disassembly.
(Figure C)
(Figure D)
|
1.800.221.0932
MetraOnline.com
Publicidad
