Important Warnings For Installation - Franke GN 86 M H XS Manual De Instalación Y Servicio

EN

Important warnings for installation

Z Z
Cooling fan shall take extra steam out and
prevent outer surfaces of appliance from
overheating during operation of oven.
This is a necessary condition for better
appliance operation and better cooking.
Z Z
Cooling fan shall continue operation after
cooking is finished.
Z Z
Fan shall automatically stop after cooling is
completed.
Z Z
A clearance must be left behind the enclosure
where you'll place the appliance for efficient
and good operation.
This clearance shouldn't be ignored
as it's required for ventilation system of the
appliance to operate.
Right place for installation
Product has been designed to be mounted
to worktops procured from market. A safe
distance must be left between the product and
kitchen walls or furniture.
See the drawings provided on pages 124 - 125
for proper distances (values in mm).
Z Z
Used surfaces, synthetic laminates and
adhesives must be heat resistant
(minimum 100 °C).
Z Z
Kitchen cupboards must be level with
product and secured.
Z Z
If there is a drawer below the oven, a rack
must be placed between oven and drawer.
GN 86 M H XS / GN 86 M H BK / GN 86 M H WH
WARNING: Do not install the product
next to refrigerators or coolers. The heat
emitted by the product increases the energy
consumption of cooling devices.
WARNING: Do not use door and/or
handle to carry or move the product.
60 Cm built-in oven installation
and mounting
X Z
Place of use for product must be located
before starting installation.
X Z
Product mustn't be installed in places which
are under the effect of strong air flow.
X Z
Carry the product with minimum two
people. Do not drag the product so that
floor isn't damaged.
X Z
Remove all transportation materials inside
and outside the product. Remove all
materials and documents in the product.
Installation under counter
Cabin must match the dimensions provided in
Figure 1.
A clearance must be provided at the rear part
of the cabin as indicated in the figure so that
necessary ventilation can be achieved.
After mounting, the clearance between lower
and upper part of the counter is indicated
in Figure 4 with „A". It's for ventilation and
shouldn't be covered.
Installation in an elevated cabinet
Cabin must match the dimensions provided in
Figure 3.
The clearances with the dimensions indicated
in the figure must be provided at the rear part
of cabin, upper and lower sections so that
necessary ventilation can be achieved.
– 8 –