Tabla De Contenido; Introduction; Warranty - Scotsman CME306 Manual Del Usuario

User Manual for
Modular Ice Cubers
models CME306 and
CME456
Table of Contents
Introduction . . . . . . . . . . . . . . . page 2
Warranty . . . . . . . . . . . . . . . . page 2
Installation. . . . . . . . . . . . . . . . page 2
Location . . . . . . . . . . . . . . . . . page 3
Plumbing . . . . . . . . . . . . . . . . page 3
Electrical . . . . . . . . . . . . . . . . page 3
Final check list . . . . . . . . . . . . . page 4
Initial start up . . . . . . . . . . . . . . page 5
Maintenance . . . . . . . . . . . . . . page 6
Failure Analysis . . . . . . . . . . . . . page 6

INTRODUCTION

This product manual contains the information needed
for the setup, installation, initial start up, sanitation and
maintenance of this ice machine. Keep it for future
reference.
Be certain that the information applies to the model in
question. If no model is listed, the information applies
to all models.

Warranty:

The warranty conditions are those supplied by the
official distributor for you area. In case of parts, only
genuine service parts may be used.
To Install The Machine
This ice machine is designed to be installed indoors, in
a controlled environment. It will operate satisfactorily
under a wide variety of conditions. Do NOT operate the
machine in temperatures it has not been designed for.
Do NOT operate the machine above or below the
voltage limits for the particular model. Do NOT operate
the machine with too little or too much water pressure.
Installation Limitations
Air Temperature
Water Temperature
Water Pressure
Voltage
(compared to the nameplate)
Inlet water flow required is 4,65 liters per minute
All models will fit a standard, 559 mm wide Scotsman
Ice Storage Bin. Some examples are:
•
BH375
•
BH360
Note: Slope front bins may need an internal baffle.
Scotsman's BH375 has the required baffle, and the
BH260 does not need one.
In addition, there may be other bins that can be used,
check Scotsman's sales literature for application
information.
Note: This unit may not be stacked.
Kits:
•
BH375 or BH360 bin: Direct Fit
•
HTB555 - Add bin top kit KBT27
•
Bins with short/no baffle require thermostat kit:
KSTAT-22.
•
IS220 or RS220 dispenser: Add kits KADCM3,
KBT27, and A37088-001.
•
HD150 dispenser: Direct Fit.
•
HD22 dispenser. Direct fit
Other combinations may be available. See Scotsman
product literature for more information.
Note: The ice machine will hang over the back of the
BH260 or SLB260 bins and the Lancer dispensers.
2
Min Max
o o
10 C. 40 C
o o
5 C. 40 C
1 bar 5 bar
-5% +10%