Siemens SITRANS FUT1010 IP65 NEMA 4X Guía Rápida página 11

Transmitter Markings and Explanations
●
●
● IP65 – Ingress protection against solid bodies, rating of dust-tight and agai
Sensor Markings and E
●
Safety Information f or Hazardous Areas
Note
Ratings under this heading apply to specific model families.
Check Your
FM-CSA installation
Read, understand and follow all safety instruction on the electronic media provided. This
equipment is rated fo
installed according to the 1010-443 installation drawing provided on the media. Failure to
install the equipment in the prescribed manner will result in unsafe operation. Follow all loca
jurisdictional safety codes when operating this equipment. When properly installed the
equipment meets the following FM – CSA ratings:
Transmitter
● Explosionproof for Class I, Division1, Groups B, C, D;
● Dust-ignit
● Intrinsically safe for Class I and II, Division 1, Groups A
● Nonincendive for Class I, Division 2, Groups A, B, C and D;
● Suitable for Class II, Division 2, Groups E, F and G outdoor (Type 4X), Class III (CSA
Sensors
● Intrinsically safe connections Class I and II, Division 1, Groups A, B, C, D, E, F and G;
● Noninc
● Suitable for Class II, Division 2, Groups E, F and G outdoor (Type 4X), Class III (CSA
● Temperature code T6 at an ambient of 40°C
FUT1010 IP65 NEMA 4X & IP66 NEMA 7 Liquid Quick Start
Operating Instructions, 1/2013, A5E02639182-AC
II (1) G [Ex ia] IIC – Transmitter located in the non-hazardous area with intrinsically
safe circuits of category Ex ia, which can be connected to Category 1 Sensors
II 3 (1) G Ex nC [ia] IIC T5 – Category 3 Transmitter located in Zone 2 for use in
potentially explosive atmosphere containing gases with intrinsically safe circuits of
category Ex ia, which can be connected to Category 1 Sensors in Zone 0
rating of water jets
xplanations
II 1 G Ex ia IIC T5 – Category 1 Sensors located in Zone 0 potentially explosive
atmosp here with intrinsically safe circuits of category Ex ia for use in potentially expl
atm osphere containing gases
Model Number: FUT1010, 7ME362x.
r use in hazardous (classified) locations as stated below and must be
ionproof for Class II, Division 1, Groups E, F and G;
only)
endive for Class I, Division 2, Groups A, B, C and D;
only)
1.2 Safety Notes
nst liquid,
, B, C, D, E, F and G;
Introduction
osive
l
9