Installing/mounting
2.4 Sensor Installation Procedure
5. It is the responsibility of the user to avoid excessive corrosion, erosion or chemical attack
Installation Procedure
Sensor is supplied with flanges suitable for handling. Lifting device should be within 10
degrees of vertical of the axis of the lifting eye.
Equipment Instability
If incorrect installation equipment is used when installing vertical sensor configurations, the
potential for injury exists.
During vertical Sensor installation use appropriate equipment to ensure safety.
Flange Failure
Incorrect selection of bolting and gasket materials which will fall within the limits of the
flange and its intended use and which are suitable for the service conditions create the
potential for injury.
The user is responsible for the correct selection of bolting and gasket materials which will
fall within the limits of the flange and its intended use and which are suitable for the service
conditions.
18
WARNING
Misuse of Equipment
It is the responsibility of the user to account for any potential confusion or misuse of gas
equipment with liquid equipment or visa versa.
Restrict use and repair to qualified personnel.
WARNING
Chemical Compatibility
If chemical compatibility of materials is ignored the potential for injury exists.
Materials of construction are chosen based on their chemical compatibility (or inertness)
for general purposes. For exposure to specific environments, check with chemical
compatibility charts before installing.
WARNING
Sensor Failure
Sensors have been designed to account for loads to internal pressures in accordance
with ASME codes. If ignored the potential for injury exists.
It is the responsibility of the user to access and account for other externally applied
loads due to earthquakes, pipe movement and other environmental conditions.
due to the use of incompatible fluids or severe conditions.
WARNING
WARNING
FUT1010 IP65 NEMA 4X & IP66 NEMA 7 Liquid Quick Start
Operating Instructions, 1/2013, A5E02639182-AC