Nogueira VFN 5000 Manual Del Usuario página 15

Side unloader
The tractor power take-off must be disconnected:
1- Remove pin A and pull the knob out to the "SIDE UNLOADER" position (fig.16 below). Replace
the pin after latching the knob.
2- Open the front shield B, place the pin in the sprocket C and latch using two cotter pins.
3- Close the front shield B.
CAUTION! Before beginning the unloading, check if the adjustment is correct. If the knob is in the
wrong position, the unloading will come out the back part of the wagon and, if the rear doors are
closed, the machine will be damaged.
SIDE
UNLOADER
A
B
(Wagon equipped with pre-dried conveyor belt)
REAR
UNLOADER
fig.16
C
FORAGE WAGON
fig.17
fig.18
Keep the pin in the sprocket.
fig.19
15