Coupling To The Tractor - Nogueira VFN 5000 Manual Del Usuario

Coupling to the tractor

The Forage Wagon must be coupled to the tractor tow hitch.
NOTE: It can also be used directly in harvesting, couple to a Nogueira Forage Harvester.
COUPLING TO THE TRACTOR:
Remove the coupling pin from tow hitch A.
Drive the tractor towards the machine so that the tow bar fits into the tow hitch of the Forage Wagon.
Insert the coupling pin A and latch B.
IMPORTANT: Remember to insert latch B in the coupling pin.
NOTES:
Use the jack to adjust the height of the two hitch.
After coupling, retract the jack and place it in the retracted position. The Wagon with 2 axles is not
equipped with a jack.
A
fig.03 fig.04
A
B
fig.06
fig.05
FORAGE WAGON
11