Drive Belt - Husqvarna 966793002 Manual Del Dueño

DRIVE BELT

1. Make sure the tension release lever is forward or
disengaged.
2. Place the belt over the pulley on the deck. Refer to
illustration for proper routing.
3. Move the tension release arm to the rear and
engage it in the latch.
BELT COVERS
1. Place the deck belt shield on the deck over
the drive pulley and secure with the hardware
removed from the steel belt shield.
2. Place the retainer on the outer pulley cover.
3. Align the tab end of the belt cover into the slot on
the deck belt shield and the other end over the end
of the outer pulley cover.
4. Secure with knob.
6
ASSEMBLY
BAGGER MOUNT
1. Attach the mount hitch to the mount tube with
1-3/4" round head shoulder bolts. Make sure the
elbowed arm of the tube is to the right, with the
mount hitch installed to the front.
2. Attach the support bracket/spacer assembly to
the tube assembly with two 1-3/4" round head
shoulder bolts.
3. Secure the lower mount hitch to the frame with a
1" hex bolt.
4. Install the mount straps (bends are to the inside)
on the outside of the mount tube using 2" hex
bolts. The front side of the mount straps are
secured to the fuel tank brackets with 1" round
head shoulder bolts and nuts.
5. To prevent contact of the left hand strap with
the EFM (Electronic Fuel Management) box on
the engine, place the foam strip on the inside of
the strap, next to the box. (Illustration location is
approximate.)
6. It may be necessary to drill holes into the rear
guard to accept the hardware for the support
bracket and spacer plate. Using the bracket as a
template, drill 5/16" holes.
7. Slip the spacer plate between the support bracket
and the rear guard and attach both to the rear
guard with 3/4" hex bolts. Tighten all hardware.
front