Husqvarna 966793002 Manual Del Dueño página 7

WEIGHTS
1. Remove the foot plate knob and foot plate. Set
aside for later reuse.
2. Remove and reserve the three rubber grommets
from the foot rest.
3. Remove the foot rest for replacement. Retain the
hardware.
4. Install the three rubber grommets to the new foot
rest and fasten the assembly to the frame with the
hardware from the old foot rest.
5. Install the foot plate and secure with the knob.
6. Fasten the weight plates to the weight brackets.
7. Secure the weight plate assembly to the front
frame of the mower between the caster wheels.
ASSEMBLY
CHUTE SUPPORT
1. Position upper chute support against bagger inlet,
flush at outer edges. See Illustration.
2. Using support as a template, drill two 3/8" holes
into bagger hood.
3. Secure upper chute support to hood with hex
bolts, washers and nyloc nuts.
4. Slip the flex trim over the bottom edge of the chute
opening.
MOUNTING COVER ASSEMBLY
NOTE: For ease of assembly, you may wish
assistance from another person for mounting the cover
assembly to mower.
1. Lift and rotate cover to align the cover brackets
with support assembly tubes.
2. Slide the cover down over the support tubes until
secure.
7