Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FITTING THE CARRIER ON THE BICYCLE
12
G
H
Place the edges of the metal bracket (G) at the holes of the frame holder (H) until you hear a click indicating the lock. This step
is extremely important for the child's safety. Check if the metal bracket (G) is locked on the frame holder (H).
13
G
The carrier has a center of gravity (F) that must be
positioned in front of the rear wheel axle. If it is positioned
behind the axle, the distance must not exceed 10 cm /
3.94 in. If the center of gravity is more than this distance
from the axle, adjust the carrier to the correct position, by
adjusting the metal bracket (G) to one of the available
positions. Centre and adjust the metal bracket (G) at a
height above the rear wheel, so that later, when you add
the weight of the child, the carrier does not touch the
wheel. Note that the metal bracket (G) should be
positioned at a maximum of 10 cm / 3.94 in away from
the wheel. These steps are extremely important for child
and cyclist safety. Check the safety of the fasteners
regularly.
03. ASSEMBLY INSTRUCTIONS
A
F
G
H
14
G
K4
6N.m
x4
K4
After adjusting the height and positioning of the carrier,
hand tighten the frame holder (H) to ensure that it
cannot move. This tightening must be manual and is
extremely important for the safety of the child. Make sure
that the frame holder (H) is firmly attached. You need to
hand tighten the 4 bolts (H4) diagonally, with the same
force and in stages - we recommend a torque of 6 N.m.
9
EN
H
Publicidad
Tabla de contenido
