Cable Assembly - Abicor Binzel ABIPLAS WELD 100 Instructivo De Servicio

®
ABIPLAS WELD 100/150 POWDER W

9.2 Cable assembly

10 Troubleshooting
BAL.0086 • 2020-12-17
1 Check screw and plug-type connections for visible damage and tight fit and
replace them if necessary.
NOTICE
• Each time the powder is changed, clean the powder delivery hose with
compressed air to remove powder residues and deposits.
• Never blow compressed air into the front of the nozzles while the torch is
connected. This may soil and destroy the flow meters in the power
source.
2 Disconnect the powder delivery hose and clean it with compressed air from
the power source side.
3 Attach the powder delivery hose.
DANGER
Risk of injury and device damage when handled by
unauthorised persons
Improper repair work and modifications to the product may lead to serious
injuries and damage to the device. The product warranty will be rendered
invalid if work is carried out on the product by unauthorised persons.
• Operating, maintenance, cleaning and repair work must only be carried
out by qualified personnel (in Germany, see TRBS 1203).
Please observe the attached 'Warranty' document. In the event of any doubts
and/or problems, please contact your retailer or the manufacturer.
NOTICE
• Please also consult the operating instructions for the welding components,
such as the power source or powder delivery unit.
10 Troubleshooting
EN - 21