Installing The Child Safety Seat (Group 1: 9-18 Kg) - Teamtex Seaty 360 Manual Del Usuario

EN
Installation method no.2: vehicle's 3-point safety belt
For children weighing up to 13, REAR-FACING installation.
Step 1: First of all, adjust the seat to its most inclined position then swivel the child
safety seat to a rear-facing position. Place it on the seat of your vehicle (refer to points 4.8
and 4.9).
Step 2: As illustrated below, pass your vehicle's 3-point seat belt through the seatbelt guides
of the child safety seat, fasten and firmly tighten the seatbelt. Make sure the vehicle's
seatbelt is well tightened and that it is not twisted.
Step 3: Place your child in the child safety seat, use the 5-point harness to secure your child.
Buckle and properly tighten the harness, make sure the height of the shoulder straps and
the headrest are properly adjusted (refer to points 4.2, 4.3, 4.4, 4.5).

5.2 Installing the child safety seat (Group 1: 9-18 kg)

Installation method no.1: ISOFIX + Top-Tether
For children weighing from 9 to 18 kg, REAR-FACING installation.
Step 1: First of all, adjust the seat to its most inclined position then swivel the child
safety seat to a rear-facing position. Place it on the seat of your vehicle (refer to points 4.8
and 4.9).
Step 2: Use the ISOFIX clips to fasten the child safety seat in place. Make sure they are
properly locked, the indicators for each clip should be green. Then push the child safety
seat back until it comes into contact with the backrest of the vehicle's rear seat (refer to
points 4.6 and 4.7).
29