Be Cool CLUB TWIN Instrucciones página 14

GB
INSTRUCTIONS FOR ASSEMBLY AND USE
UNFOLD AND USE
1. To unfold Frame: See Fig 1-B, release the locked folding latch 1-A; Hold handle grip by one hand, push
forward away the front leg until more than half has been unfolded 1-B; Step down the plastic pedal on
cross bars and lift up handle grips 1-C and now the pushchair is fully unfolded.
2. To assemble/disassemble front wheels: Assemble: Align the front wheel house hole with the steel pin
as Fig 2.A. Slide the wheel upwards and press until the wheel clicks into position. Repeat on both sides.
Check the wheels are secure by pulling gently downwards. Disassemble: Press in the release button and
pull outside wheels set to disassemble. To use front swivel wheel lock : See Fig 2.B: Lift up the swivel lock
evers, the front wheels are locked;
Press down the front wheel lock levers, the front wheels are free to swivel .
3. To Assemble the rear wheels: Assemble: See Fig 3, align the rear wheels house holes with rear legs
tubes. Slide the wheels upwards and press until the wheels clicks into position and the spring pins spring
out from the small round holes on the front side of the plastic houses. Check the wheels sets are secure by
pulling gently downwards and checking the spring pins springing out.
4.To assemble/disassemble the canopy: Assemble: Align the canopy frame lacths with the plastic spring
house holes on handles. press into until hear "clicks". Disassemble: Press up the plastic spring from the
bottom hole of plastic house,pull outside canopy frame to disassemble.
5. To use brakes: Step down brake levers and the pushchair is braked. Lift up brake lever and the braking
is released.
MAINTENANCE
Do not expose the upholstery material to the sun during long periods.
Wash plastic parts with warm water and soap, then dry all components thoroughly.
14
IM 1340,02 TWIN CLUB BCOOL 1ins.indd 14 9/9/11 12:55:10