Attaching The Belt Clip; Charging The Batteries - Gigaset C530 IP Manual Del Usuario

Gigaset C530 IP / LUG - USA en / A31008-XXXXX-XXXX-X-XX / starting.fm / 25.03.2015
Getting started

Attaching the belt clip

The handset has notches on each side to attach the belt clip.
u
To attach — press the belt clip onto the back of the handset
so that the tabs on the belt clip click into place in the
notches.
u
To remove — press the centre of the belt clip firmly with
your right thumb, push the fingernail of your left thumb up
between the clip and the casing and pull the clip in an
upward direction.

Charging the batteries

The batteries are supplied partially charged. Please charge completely before use. The batteries
are fully charged when the power icon
Notes
u
The handset may only be placed in the designated base/charging cradle.
u
The battery may heat up during charging. This is not dangerous.
u
After a time, the charge capacity of the battery will decrease for technical reasons.
u
Handsets contained in the package have already been registered to the base. If, however,
a handset has not been registered ("Please register handset" or "Place handset in base"
is displayed), please register it manually (
10
disappears from the display.
¤
Charge the handset in the charging cradle for
6 hours.
6h
The charge status is shown on the idle display:
xy xy x{ x{
¢
page 69).
(empty to full).