Installation - Yamaha ATS-930 Manual De Instrucciones

Installation

Place the sound bar on a flat surface such as on top of a
TV cabinet.
Cautions
• Do not place the sound bar on/under any other devices such as
BD player in a pile. Doing so may cause a malfunction due to
vibrations.
• Do not touch the grilles (fabric parts) on the front of the sound
bar.
• The sound bar contains acoustic suspension speakers. Do not
place magnetically sensitive items (hard disk drive, etc.) near the
sound bar.
• Depending on your installation environment, it may be better to
connect the sound bar and external devices (such as a TV)
before installing the sound bar.
• Do not place the sound bar within 50 mm (2") of the TV. The wall
mount brackets on the rear panel can be removed as necessary.
Removing the stands
When the sound bar blocks the view of the lower part of the
TV screen or the remote control sensor of the TV, remove the
stands (18 mm [3/4"]) of the sound bar to adjust its height.
HINT
• Use the TV Remote Repeater function (p.12) to transmit TV's
remote control signals via the sound bar.
NOTE
• Keep the stands and screws in a safe place for future use.
Attaching the sound bar to a wall
Cautions
• When installing the sound bar on a wall, all installation work must be
performed by a qualified contractor or dealer. The customer must never
attempt to perform this installation work. Improper or inadequate
installation could cause the sound bar to fall, resulting in personal injury.
• Do not attach the sound bar to a wall that is made of weak
materials such as plaster or veneered woods. Doing so may
cause the sound bar to fall.
• Make sure you use commercially available screws that can
support the weight of the installation (specified in Step 2 on the
right). Using clamps other than specified screws, such as short
screws, nails, and two-sided tape, may cause the sound bar to fall.
How to install on the wall
1 Attach the mounting template on a wall and mark
for the screw holes.
Tapes or thumbtacks
Mounting template (supplied)
Screw
holes
2 Remove the mounting template from the wall,
then install commercially available screws and
supplied spacers (as illustrated below) at the
points marked on the wall.
Spacer (supplied)
7 to 9 mm
(1/4" to 3/8")
2 to 4 mm (1/16" to 3/16")
3 Hang the sound bar on the screws.
Mounting holes
on rear of sound bar
Cautions
• Fix the cables in place where they will not become loose. If your
foot or hand accidentally gets caught on a loose cable, the sound
bar may fall.
• Check that the sound bar is fixed securely after the installation.
Yamaha will bear no responsibility for any accidents caused by
improper installations.
4 mm (#8)
20 mm (3/4")
or more
5
En