Selecting A Source - Pioneer AVD-W1100V Manual Del Propietário

Basic Operation

Selecting a Source

Switches video and audio source inputs from the AV equipment connected to VCR1 IN,
VCR2 IN, or COMPONENT IN.
1. Select a source.
Press the SOURCE/POWER button. Each press of the button selects the desired source in
the following sequence:
[VCR1 (COMPONENT)] or [VCR1] = [VCR2] = Exit to [VCR1 (COMPONENT)] or
[VCR1]
Note:
• This product has two source inputs; VCR1 IN and VCR2 IN.
VCR1 IN has a component video input [VCR1(COMPONENT)] as well as an RCA video input
[VCR1].
• [VCR1 (COMPONENT)] is a component video from the AV equipment connected to the VCR1 IN
COMPONENT terminal. 26pin component cable (CD-CP300), which is sold separately is required.
(Refer to page 28.)
• VCR1 COMPONENT input is given priority over VCR1 RCA input when both input are connected
at the same time.
• A video input terminal which is not connected cannot be selected even if the SOURCE/POWER
button is pressed.
• [VCR1] is selected when no connection is made for both VCR1 and VCR2 input.
11
VCR1 [ COMPONENT ]