Tools And Materials; Before You Begin - Kohler K-669 Guia De Instalacion

Tools and Materials

Pipe Adjustable
Wrench Wrench
Strap
Wrench
Assorted
Screwdrivers

Before You Begin

DANGER: Risk of scalding or other severe injury. Before
completing installation, the installer must set the maximum
water temperature setting of this valve to minimize the risks
associated with scalding hazards according to ASTM F 444.
CAUTION: Risk of scalding. This device has been calibrated
at the factory to ensure a safe maximum water temperature.
Any variance in settings or water inlet conditions from those
used during factory calibration may raise the discharge
temperature above the safe limit, and may present a scalding
hazard. Responsibility for installation and adjustment of this
device in accordance with these instructions lies with the
installer.
CAUTION: Risk of product damage. This valve contains
plastic and rubber components. Do not sweat or braze
directly to the valve body. Do not apply excessive heat to the
valve body when you make solder connections. Do not apply
flux or acids directly to the valve, as damage to the seals,
plastic components, and trim finish may result.
CAUTION: Risk of product damage. Do not apply
petroleum-based lubricants to the valve components, as
damage may result.
Kohler Co.
Hacksaw or
Tubing Cutter
Thread
Sealant
Thermometer
3
Solder
Propane
Torch
3/8" Socket
Wrench or Drive
1041158-2-F