Pentair RO-2600 Manual De Instalación Y Operación página 6

INSTALLATION continued
7. Connecting the Faucet to the System
A. Locate the reject tubing (reject water line) from the
drinking water faucet. This tube is the smaller of the
two. Place a mark on the tubing 5/8-inch from the end.
Moisten the end of the tubing with water and insert
tubing into the quick-connect fitting on the flow restrictor
found on the right side of system behind the membrane.
If tubing is not firmly connected, leaking will occur. It
is important for the tubing to be inserted all the way
until the mark is flush with the outer edge of the quick-
connect insert.
1/4" Feed
Tube
6 • SE11 Model RO-2600 5 StageReverse Osmosis System
NOTE: Tubing may be quickly and easily removed from
B. The faucet tube from the bottom of the threaded metal
3/8" Drain
Tube
1/4" Faucet
Permeate Tube
3rd Stage
Carbon Block
Figure 12
the fitting if necessary by pressing the collar
around the fitting then pulling the tubing with
your other hand.
tube is inserted into the post filter. The fitting is at the
top left of the RO System. Push the free end of the
tubing into the quick connect fitting.
1/4" Faucet
Drain Tube
2nd Stage
GAC Filter
1/4" Storage Tank
Permeate Tube
1st Stage
Prefilter