Optional Accessories; Environmental Conditions For Normal Use - Enraf Nonius Endolaser 422 Manual De Uso

4.1.2

Optional accessories:

Model
1422.816 Laserprobe with one diode laser 905nm (LP025)
1422.817 Laserprobe with one diode laser 905nm (LP100)
1422.818 Laserprobe with one diode laser 808nm (LP500)
1422.819 Clusterprobe with four diode laser 905nm (CP400)
Check the contents of the package and should any of the items be missing then contact your local
authorized Enraf-Nonius BV. dealer.
Save the original box and all the packing materials in case of return to manufacturer or your dealer.
WARNINGS:
•
Do not use accessories other than the original ones supplied: these could damage the machine
and void the warranty claim. In the event that problems or installation problems occur, contact the
Enraf Nonius technical assistance service.
•
The use of accessories, transducers and cables, other than those specified or supplied by Enraf
Nonius, could lead to higher electromagnetic emissions or a decrease in the level of
electromagnetic immunity of the appliance, with consequent incorrect operation.
4.1.3

Environmental conditions for normal use

Installation of the equipment is fast and simple and does not require any particular attention. The
following environmental conditions are ideal when installing the unit:
Room temperature
Humidity level
Atmospheric pressure
Avoid direct exposure to sunlight, chemical products and vibrations.
CAUTION:
In the indicated temperature range, during normal use, laser probe can reach the following temperatures
without increasing the risk to the patient's health.
•
LP100 49.9 °C
•
LP025 50.3 ° C
•
CP400 61.9 ° C
•
LP500 64.7 ° C
CAUTION:
•
Do not use Endolaser equipment wherever there is a risk of either the external or internal parts of
the unit becoming wet.
•
It is absolutely forbidden to use the device in the presence of flammable anesthetic mixtures and
oxygen rich environments. In case of non-compliance with the information provided, Enraf-Nonius
B.V. will not be held responsible for any accidents.
EN
4
: 10°C to 40°C
: 10% to 80% non condensing
: 500 to 1060 hPa
Average Power Peak Power
25 mW
100 mW
500 mW 500 mW
4 x 100 mW 4 x 100 W
25 W
100 W