Load A Programme On Channel 2 - Enraf Nonius Endolaser 422 Manual De Uso

NOTE: The Endolaser 422 has two independent output channels. On each channel you can set
parameters or load a pre-programmed protocol. Repeat the operation as described above with the other
channel.
5.7.3 Select Program
The memorized programs available have been specially created by professional and expert operators
after years of experience in the field.
A list of all available programs can be found in Appendix B.
•
Select with push button [1] Select Program in the
main menu.
•
Select a program from the list with the central
controller [11]
•
Confirm the selection with the confirmation button
[10]
•
The program will be loaded on both channels

5.7.3.1 Load a programme on channel 2

•
Select Channel 2 with button [1]
•
Go to Select Program with the central controller [11]
•
Confirm the selection with confirmation button [10]
•
Select a program from the list with the central
controller [11]
•
Confirm the selection with the confirmation button
[10]
•
To start the emission push the start button [5] the
Stop symbol ◼ change to running 
•
To interrupt the treatment push the stop button [6]
once. Running symbol  change to pause 
•
To Stop the treatment push the stop button [6]
again when the pause symbol is active
•
Push Return button [2] to return to the main menu
User Programs

Return
Select Program
Acne

Arthritis
Cervical Syndr.1
Cervical Syndr.2
Cervical Syndr.3
Cervical arth.1
Cervical arth.2
Cervical arth.3
Hypertro. Scars

Select Channel 2

Return
Arthritis
Channel < 1 >

Freq.: 5000Hz
Time: 00:20 s
Dosage: 6 J/ cm²
Select Program
◼ ◼
MLA-1
00:00
0,1 J/cm²

12 mWatt
MLA-3
00:00
EN
13