Switch Housing Plate - Harbor Breeze LYNNHAVEN DTA54GPT5CL Manual Del Usuario

FINAL INSTALLATION
7.
Remove one screw from fitter plate on underside of
motor housing (D) and partially loosen the other two
screws. Raise switch housing plate (H) to motor,
allowing the male plug from the motor housing (D) to
come through the large hole in the switch housing
plate (H). Align slotted holes in switch housing plate
(H) with loosened screws in fitter plate and twist
switch housing plate (H) to lock. Re-insert screw that
was just removed, and then tighten all three screws.
(Fig. 7)
8. Remove finial (U) from threaded rod on switch
housing plate (H) and save for later use. Raise
switch housing (J) up toward switch housing plate
(H). Connect male plug from motor housing (D) to
female plug from switch housing (J), matching up
the colors on the male plug with the colors on the
female plug for correct fit. (Fig. 8) Make sure that
the plugs are connected completely. Carefully
arrange wiring inside of switch housing (J).
9. Align threaded rod on switch housing plate (H)
with hole on the bottom of the switch housing (J)
and push up. Secure switch housing (J) by
attaching finial (U) that was removed in previous
step. Make sure finial (U) is securely tightened.
(Fig. 9)
10. The pull chain extensions (K) supplied in one of the
hardware packs or custom pull chain extensions
(sold separately) may be attached to fan and light
pull chains. (Fig. 10)
NOTE: This fan is remote control adaptable (remote
control sold separately).
7
Fitter Plate
8
L
Threaded
Rod
U
9
Threaded
Rod
10
12
H
Male Plug
H
Male Plug
Female Plug
J
H
J
U
K
L
M
M
L
M