Installation Instructions; Installation; Positioning; Electrical Connection - Fulgor Milano FCLH 9008 ID WT Installación Uso Y Mantenimiento

4 - Installation instructions

EN

Installation

these instructions are aimed at qualified fitters as a guide to
installation, adjustment and maintenance in compliance with
the laws and standards in force. The operations must always
be carried out with the appliance disconnected from the
electricity supply.

Positioning

The appliance is made to be fitted into a counter top, as show
in the figures at page 18. Apply the sealant supplied around
the whole perimeter of the hob. Installation over an oven is not
recommended, but if this is necessary, check that:
• the oven has an efficient cooling system;
• there is no passage of hot air from the oven to the hob;
• allow air passages as shown in the figure.

Electrical connection

Before connecting to the electricity supply, ensure that:
• the characteristics of the system are such as to satisfy that
indicated on the registration plate applied to the bottom of
the hob;
• the system has an effective earth connection compliant with
the standards and laws in force. Connection to earth is
compulsory by law.
If the appliance has no cable and/or plug, use material
suitable for the absorption indicated on the registration plate
and for the working temperature. The cable must not reach a
temperature higher than 50°C above room temperature in any
point.
For direct connection to the network it is necessary to fit an
omnipolar switch of a suitable size to ensure disconnection
of he network with a contact opening distance that allows
complete disconnection in the conditions of the overtension
category III, compliant with the installation regulations (the
yellow/green earth wire must not be interrupted).
The omnipolar socket or switch must be easy to reach when the
appliance is installed.
N.B.:
• The manufacturer declines all responsibility if the usual
accident prevention standards and the above instructions
are not observed.
If the power cable is damaged, it must be replaced by the
manufacturer or by the manufacturer's technical servicing
network, or by a similarly qualified operator, to prevent every
possible risk.
VSee the power supply cables table, page 20.
16

List of errors displayed

In case of errors or malfunctions of the hob, a number of error
codes may appear on the display.
The intervention must be performed by technical assistance
and by a specialist technician.