Fulgor Milano FCLH 9008 ID WT Installación Uso Y Mantenimiento página 39

Error message Description
ER03 +
Permanent Key activation,
Steady tone
interface shut down at 10s
ER 20
Flash - failure
ER21
Control unit shuts down, caused by
overtemperature, to avoid damage
of the touch control
ER22
Defective Key evaluation . Control
unit cuts off after 3.5 - 7.5 sec.
ER31
Configuration data is wrong
ER36
NTC value is not within its
specification (value < 200mV or >
4.9V; control unit cuts off
ER40
Secondary voltage is min.5s to
low (1,8V< UPowerfail< 2,9V)
ER47
Communication failure
between induction and Touch
Control
E2
Overtemperature on the
cooking zone
E6
Failure of the power unit
E7
Unknown mistake
E8
Fan failure
E9
Broken coil temperature sensor
U 400
Secondary voltage of the
power unit to high (primary >
300V).
Control unit cuts off after 1 sec
releasing a permanent tone.
E/A
Error on power board or
supply element
Possible error reason
Water or cookware on the glass
above the interface
µ C- faulty
Control algorithm has reached
overtemperature, because ambient
temperature is to high
Short-circuit or discontinuation in
the range of the key evaluation
Configuration of the induction
neccessary
Short-circuit or cut-off at NTC
Primary-PTC to hot
No or incorrect communication
Fan or control electronics of the
fan are broken
Control unit is wrongly
connected.
No power supply of the power
element or error on power
board
Troubleshooting
Cleaning of the
Exchange control unit
Let cooktop cool down, check
temperature isolation to user
interface
Exchange control unit
New configuration
Exchange control unit
Disconnect interface from
power supply
Connection cable broken or
incorrect mounted
Let the system cool down
Change power
Change induction modul
Change induction modul
Change coil sensor
Connect to correct mains
voltage
1. Check wiring
2. Check filter board
3. Replace power board
EN
17