Maintenance; Cleaning And Disinfection; Reconditioning; Recycling - Etac molift MRS Duo Flex Manual De Usuario

Molift MRS Duo Flex / www.etac.com

Cleaning and disinfection

Clean on a regular basis. Clean surfaces with
a damp cloth using an appropriate pH-neutral
detergent. Do not use solvents or strong liquids,
this may damage surfaces on the lifter. For
disinfection when needed; use isopropyl alcohol.
Avoid abrasive cleaning products. Remove hair
and pile from the castors and verify that the
castors rotates freely. Clean contact and hand
control with isopropyl alcohol to remove grease
and dirt.
Make sure not to damage or
remove labels when cleaning.

Periodic Inspection Scope

Periodic inspection is a visual examination (particu-
larly MRS Duo Flex structure, bolts and lifters with
attachments, safety devices and person-support
devices) according to Periodic Inspection Report
for MRS Duo Flex. This can be found on www.
etac.com.
In the event of danger to safety,
the gantry shall immediately be
taken out of service and marked
clearly with "out of order" and
shall not be used until MRs Duo
Flex is repaired
Periodic Inspection shall be performed at least
once a year or more frequently if required by local
requirements. The inspection should be performed
by service personnel authorized by Etac. Contact
Etac for training and authorization or recommen-
dation of an approved service partner.
When performing a periodic inspection, the
inspector shall fill out the inspection report for
MRS Duo Flex. The reports should be retained by
the person(s) responsible for servicing the lifter. If
the inspection reveals defects and damages, the
owner shall be notified and a copy of the report

Maintenance

Reconditioning

Follow cleaning and assembly procedure, complete
periodic inspection and use checklist after assem-
bly to recondition MRS Duo Flex.

Recycling

Molift MRS Duo Flex can be disposed of as metal
waste exept the battery charger. Battery charger
must be removed and disposed of as Electrical
equipment.

Spare Parts

A list of spare parts is available on demand

Periodic Inspection

should be sent to Etac, molift@etac.com.
When periodic inspection is completed the
inspector shall mark the gantry with a sticker on
the control label showing the date when periodic
inspection is performed and a label (with 6-digit
ID from Etac or distributor) showing who has per-
formed the periodic control. The control label can
be found on the post, and this will then indicate
when next service should be performed.
9
Mark label
with month
and year of
inspection