Assembly; Supplied Parts; Mounting Telescopic Boom; Mounting Base - Etac molift MRS Duo Flex Manual De Usuario

Supplied parts

1
2
8
MRS Duo Flex
User manual
BM21099 Rev B 2015-05-28
3
4 5 6
1 Telescopic boom
2 Post
3 Allen key 6mm
4 Allen key 5mm
Make sure the following parts are included in the
package.
Beware of sharp edges at the ends
of the boom.

Mounting telescopic boom

1. Place the column on the floor with the 2 holes
facing sideward.
2. Place the boom between the columns.
3. Connect the columns with the boom and
tighten the 2 screws (M10).
4. Repeat the procedure at the opposite side.
Ensure that the joint is stable,
otherwise the 2 post system will be
unstable and not safe to use
7
1x 5 Allen key 4mm
2x 6 DIN 912 M5x12
1x 7 Base
1x 8 User manual

Assembly

Mounting base

1x
2x
2x
1x
1. Lift the column slightly and connect the base.
2. Tighten the 4 screws (M8) under the base.
3. Repeat the procedure at the opposite side.
4. Raise the MRS Duo Flex to an upright position.
It can be an advantage to lock the castors.
Ensure that the joint is stable,
otherwise the 2 post system will be
unstable and not safe to use

Mounting charger to column

1. Fasten lover screw first (M5).
2. Place charger on screw and insert upper screw
(M5).
3. Use allen key and tighten bolt.
6
Molift MRS Duo Flex / www.etac.com
Upper screw
Lower screw