Invacare InTouch Flovair ITFG Instrucciones De Armado, Instalación Y Operación página 5

Removing Inner Cover
NOTE: For this procedure, refer to FIGURE 3.
1. Remove the seat from the outer cover. Refer to Removing the Outer Cover on
page 4.
2. Unflap the inner cover.
3. Remove the seat from the inner cover.
Installing Inner Cover
NOTE: For this procedure, refer to FIGURE 3.
1. Position the seat with the fluid/air insert toward the rear of the inner cover.
NOTE: The back surface of the seat is
marked "REAR".
2. Slide the seat into the inner cover.
3. Fold the top flap over and tuck it
into the bottom cover.
4. Fold the bottom flap back.
5. Reinstall the seat, with inner cover
in place, into the outer cover. Refer
to Installing Outer Cover on page 4.
Removing/Installing Pelvic Support Layer
NOTE: For this procedure, refer to FIGURE 4 on page 6.
NOTE: The seat comes with a fluid/air pelvic support layer.
Removing Pelvic Support Layer
1. Remove seat from inner and outer covers. Refer to Removing/Installing Seat
Covers on page 4.
2. Unfasten the front strap, the rear strap, and the two side straps.
3. Lift the existing pelvic support layer and remove from the foam.
Installing Pelvic Support Layer
1. Center the pelvic support layer on the foam so that the side straps are centered
in the contours on each side of the foam.
2. Fasten the rear, front, and side straps together at the bottom of the foam.
NOTE: DO NOT over‐tighten the straps. The pelvic support layer must be free to move
with the seat.
3. Reinstall seat into inner and outer covers. Refer to Removing/Installing Seat
Covers on page 4.
Part No 1141447
Insert - Toward
Rear of Inner
Cover
Inner Cover
FIGURE 3 Removing Inner Cover -
Installing Inner Cover
5
Seat
Top Flap
Bottom Flap
InTouch™ Flovair Seat