Hitachi SJ300 Serie Guía Referencia Rápida página 26

Func.
Code
C031 Terminal [11] active state
C032 Terminal [12] active state
C033 Terminal [13] active state
C034 Terminal [14] active state
C035 Terminal [15] active state
C036 Alarm relay terminal
active state
C040 Overload signal output mode
• 00 During accel/decel
• 01 During constant speed
C041 Overload level setting
C042 Frequency arrival setting for accel
C043 Arrival frequency setting for decel
C044 PID deviation level setting
C045 Frequency arrival setting for accel (2)
C046 Frequency arrival setting for decel (2)
C055 Over-torque (forward-driving) level setting
C056 Over-torque (reverse regenerating) level
C057 Over-torque (reverse driving) level
C058 Over-torque (forward regenerating) level
C061 Electronic thermal warning level
C062 Alarm code output
• 00 Disable
• 01 Enable, 3-bit code
• 02 Enable, 4-bit code
C063 Zero speed detection level
C070 Data command method
• 02 Digital operator • 03 RS485
• 04 Expansion card #1
• 05 Expansion card #2
C071 Communication speed selection
• 02 (Test)
• 04 4800bps
• 06 19200bps
C072 Node allocation
C073 Communication data length selection
• 07 7-bit data
Name / Description
• 00 Normally
open (NO)
• 01 Normally
closed (NC)
• 03 2400bps
• 05 9600bps
• 08 8-bit data
of each inverter
24
Default Value
–FE / –FU /
–FR
00
00
00
00
00
01
01
Rated current
0.00
0.00
3.0
0.00
0.00
100.
100.
100.
100.
80.
00
0.00
02
04
1.
7
Set
Value