Migatronic SIGMA2 300 COMPACT Guía De Usuario página 13

Connection and start-up
Various wire feed units
Use of MWF 41 Master and Slave
The slave unit is active and the green LED will
be turned on after a short pressure on the hose
trigger.
All settings are carried out on the master control
panel and will be automatically saved until the
slave unit is activated.
Please note that MWF 41 Slave and RWF have the
same functions.
Software reading
• Insert the SIGMA SD-card in the slide in the
right side of the machine.
• Turn on the machine.
• The display flashes shortly with six lines.
• Wait until the set current is displayed.
• Turn off the machine and remove the SD card.
• The machine is now ready for use.
All connected wire feed units will be updated
with the new software.
It is necessary to read software inside the new
control unit by means of a SD card, if the control
unit has been exchanged.
The software can be downloaded from
http://migatronic.com/login
Use of MWF 41
Master and Slave
13