Polisher LK 602 VR
Continuous operation with engaged
switch rocker:
`^rqflk>
Following a power failure, the switched-on
machine will start running again. Always switch
off the power tool!
First press (1.) and hold down the starting
lockout and then the switch (2.).
To lock into position, hold down the
locking button and release the switch (3.).
Release switch interlock (4.).
Switch off the machine:
To switch off, briefly press and release
the switch.
Preselecting the speed
To set the operating speed, move the dial
to the required value.
Gently press the switch to accelerate the
power tool up to the preselected speed.
klqb
If an overload or overheating occurs during
continues operation, the power tool auto-
matically reduces the speed until the power
tool has cooled down adequately.
Attach handle cover only
`^rqflk>
Never use the power tool without the second
handle (handle cover or side handle).
Attaching or changing the
tool holder
Pull out the mains plug.
Press and hold down the spindle lock.
Screw the tool holder (Velcro pad, fleece
pad) clockwise onto the spindle and
tighten hand-tight.
17