Tabla De Contenido; Safety Instructions - Emerson ASHLAND CF717AP02 El Manual Del Propietario

Section
Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
1. Unpacking Instructions . . . . . . . . . . . . . . . . . . . . . . . . . .3-4
2. Electrical Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . 4
3. Installing Hanger Ball/Downrod Assembly . . . . . . . . . . .5-7
4. Installing Ceiling Cover on Fan Motor Housing . . . . . . . . 8
5. Installation of Hanger Bracket . . . . . . . . . . . . . . . . . . .9-10
6. Hanging the Ceiling Fan (Standard) . . . . . . . . . . . . . . . . 11
7. Hanging the Ceiling Fan (Close-to-the-Ceiling) . . . . . . . 11
8. How to Wire Your Ceiling Fan . . . . . . . . . . . . . . . . . . . . 12
9. Installation of Ceiling Cover . . . . . . . . . . . . . . . . . . . . . . 13
READ AND SAVE THESE INSTRUCTIONS
WARNING
!
TO REDUCE THE RISK OF FIRE, ELECTRICAL
SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
a. Use this unit only in a manner intended by the
manufacturer. If you have questions, contact the
manufacturer.
b. Before servicing or cleaning unit, switch power
off at service panel and lock service panel
disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a warning device, such as a tag, to the
service panel.
1. Read your owner's manual carefully and keep it for
future reference.
2. Be careful of the fan and blades when cleaning,
painting, or working near the fan. Always turn off the
power to the ceiling fan before servicing.
3. Do not put anything into the fan blades while they are
turning.
4. Do not operate reversing switch until fan blades have
come to a complete stop.
Additional Safety Instructions for Installation
1. To avoid possible shock, be sure electricity is turned
off at the fuse box before wiring, and do not operate
fan without blades.
2. All wiring must be in accordance with the National
Electrical Code "ANSI/NFPA 70-2017" and Local
Electrical Codes. Use the National Electrical Code
if Local Codes do not exist. The ceiling fan must be
grounded as a precaution against possible electrical
shock. Electrical installation should be made or
approved by a licensed electrician.
Table of Contents
Page Section
10. Installation of Ceiling Fan Blades . . . . . . . . . . . . . . . . . 14
11. Installation of Light Fitter to Switch Housing . . . . . . .15-17
12. Installation of Light Kit Assembly . . . . . . . . . . . . . . .18-21
13. Using Your Ceiling Fan . . . . . . . . . . . . . . . . . . . . . . . . . 21
14. Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
15. Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
16. Trouble Shooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
17. Repair Parts. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .24-26
Ceiling Fan Limited Warranty . . . . . . . . . . . . . . . . . . . . . . . 27
Spanish . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29
French . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 57

Safety Instructions

3. The outlet box and joist must be securely mounted
To reduce the risk of injury, install the fan so that the
blades are at least 7 ft. (2.1m) above the floor.
4. The downrod furnished with the fan provides the
5. Follow the recommended instructions for the proper
NOTE:
controls.
NOTE:
where necessary before installation.
To reduce the risk of electrical shock, this fan must be
installed with an isolating wall control/switch.
To avoid fire, shock or injury, do not use an Emerson
or any other brand of control not specifically approved
for this fan.
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use this product.
Substitution of parts or accessories not designated
for use with this product by Emerson could result in
personal injury or property damage.
To reduce the risk of personal injury, do not bend
the blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades.
2
and capable of reliably supporting at least 50 pounds.
Use only U.L. outlet boxes listed as "Acceptable for
Fan Support of 22.7 kg. (50 lbs.) or less", and use
the mounting screws provided with the outlet box.
Most outlet boxes commonly used for support of light
fixtures are not acceptable for fan support and may
need to be replaced. Consult a qualified electrician if
in doubt.
CAUTION
!
minimum recommended floor to fan blade clearance
for an 8 foot ceiling.
method of wiring your ceiling fan. If you do not know
enough about electrical wiring, have your fan installed
by a licensed electrician.
This fan is suitable for use with solid-state speed
All setscrews must be checked and re-tightened
WARNING
!
Page
ETL Model No.: CF717-2