Important; Installing Hanger Ball/Downrod Assembly - Emerson ASHLAND CF717AP02 El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Your ceiling fan is designed to be installed either in the standard manner, or in the
close-to-the-ceiling manner. Using the standard method, the hanger ball/downrod assembly will suspend
the fan several inches below the ceiling cover. Using the close-to-the-ceiling method, the ceiling cover
installs directly on the fan motor housing, thus mounting the fan 3-1/2 inches closer to the ceiling than the
standard method. In no case should the fan blades be lower than seven feet above the floor. Depending
on your desired mounting method, proceed to "3. INSTALLING HANGER BALL/DOWNROD ASSEMBLY"
for standard mounting, or to "4. INSTALLING CEILING COVER ON FAN MOTOR HOUSING" for
close-to-the-ceiling mounting.

3. Installing Hanger Ball/Downrod Assembly

3.1
Remove the Hanger Ball by loosening the Set Screw
in the Hanger Ball until the Ball falls freely down the
Downrod (Figure 1).
Remove the Pin from the Downrod, then remove
the Hanger Ball. Retain the Pin and Hanger Ball for
reinstallation in Step 3.6.
3.2
Separate, untwist and unkink the Three 80" Motor
Wires. Route the Motor Wires through the Downrod.
Loosen the Two Set Screws preinstalled on the Motor
Coupler.
Align the Clevis Pin Holes in the Downrod with the
Holes in the Motor Coupler. Install the Clevis Pin and
secure with the Hairpin Clip (Figure 2).
The Clevis Pin must go through the Holes in the Motor
Coupler and the Holes in the Downrod. Be sure to push
the straight leg of the Hairpin Clip through the Hole near
the end of the Clevis Pin until the curved portion of the
Hairpin Clip snaps around the Clevis Pin.
The Hairpin Clip must be properly installed to prevent
the Clevis Pin from working loose. Pull on the Downrod
to make sure the Clevis Pin is properly installed.

IMPORTANT

(For Standard Mounting)
Figure 1
Figure 2
5
PIN
HANGER BALL
PHILLIPS HEAD SET SCREW
(LOOSENED)
SETSCREW (2)
SET SCREWS (2)
SETSCREW
CLEVIS PIN
CLEVIS PIN
CLEVIS PIN
Please contact 1-800-654-3545 for further assistance
GREEN GROUND WIRE
4.5" DOWNROD
DOWNROD
DOWNROD
DOWNROD
HAIRPIN
HAIRPIN
HAIRPIN
CLIP
CLIP
CLIP
MOTOR
MOTOR
COUPLING
COUPLER
MOTOR
COUPLING
emersonfans.com
ETL Model No.: CF717-2

Publicidad

Tabla de contenido
loading

Tabla de contenido