Tripp-Lite B024-DUA8-SL Manual Del Propietário página 10

Installation
1
Connect a monitor to the KVM using one of the three following methods:
a. DVI Monitor – Connect the DVI port on the monitor to the DVI-I console port
located on the rear of the KVM switch.
b. DVI + VGA Monitor – For monitors with DVI and VGA ports, you can connect
both to the KVM switch. Connect the DVI port on the monitor to the KVM's
DVI-I console port, and the VGA port on the monitor to the KVM's VGA console
port.
c. DVI and VGA Monitors – Connect a DVI monitor to the DVI-I console port on
the KVM, and a VGA monitor to the VGA console port.
Note: Only one video signal will transmit at a time. When connecting to both the DVI and
VGA ports on a single monitor, or when connecting DVI and VGA monitors at the same
time, the video output used will be determined by the OSD settings. See the Set Computer
Video Input section in this manual for details.
2
Connect a USB keyboard and mouse to the corresponding USB keyboard and
mouse console ports located on the rear panel of the KVM switch.
3
Optional – Connect a microphone and speakers to the corresponding 3.5 mm
console jacks located on the unit's front or rear panel. The front panel jacks will
take priority over those on the rear panel.
4
Optional – Connect USB device(s) to the USB 2.0 hub port(s) on the front and
rear of the KVM switch.
5
Connect the KVM cable kit to the KVM switch. The USB-B male connector side
plugs in to an available set of computer ports on the unit's rear panel. Connect
the DVI-D connector to the DVI-I port, and the USB and 3.5 mm connectors to its
corresponding USB and 3.5 mm ports.
Note: KVMs include two 6 ft. cable kits. For the remaining ports requiring cables, or if a
longer cable is needed, separate P759-Series DVI/USB + Audio KVM Cable Kits are needed
(sold separately).
6
Connect the other end of the KVM cable kit to the corresponding ports on the
computer you wish to add to the installation.
7
Repeat steps 5 and 6 for each additional computer added to the installation.
8
Connect the included power supply to the KVM switch, then plug it into an
appropriate power source. To help protect your system from sudden transient
increases and decreases in electrical power, plugging your devices into a Tripp
Lite surge protector, line conditioner, or uninterruptible power supply (UPS) is
recommended.
9
Turn on the power to all connected computers and devices.
17-10-479-93370A.indb 10
10
11/17/2017 2:28:59 PM