Tripp-Lite B024-DUA8-SL Manual Del Propietário página 13

Installation
8
Connect the KVM cable kit to the KVM switch. The USB-B male connector side
plugs in to an available set of computer ports on the unit's rear panel. Connect
the DVI-D connector to the DVI-I port, and the USB and 3.5 mm connectors to its
corresponding USB and 3.5 mm ports.
Note: KVMs include two 6 ft. cable kits. For the remaining ports requiring cables, or if a
longer cable is needed, separate P759-Series DVI/USB + Audio KVM Cable Kits are needed
(sold separately).
9
Connect the other end of the KVM cable kit to the corresponding ports on the
computer you wish to add to the installation.
10
Repeat steps 8 and 9 for each additional computer added to the installation.
11
To properly power on the installation, first connect the included power supply to
each third level KVM switch in the installation, then plug it into an appropriate
power source. To help protect your system from sudden transient increases
and decreases in electrical power, plugging your devices into a Tripp Lite surge
protector, line conditioner, or uninterruptible power supply (UPS) is recommended.
12
Connect the included power supply to each second level KVM switch, then plug it
into a Tripp Lite surge protector, line conditioner, or uninterruptible power supply
(UPS).
13
Connect the included power supply to the first level KVM switch, then plug it
into a Tripp Lite surge protector, line conditioner, or uninterruptible power supply
(UPS).
14
Turn on the power to all connected computers and devices.
17-10-479-93370A.indb 13
13
11/17/2017 2:29:00 PM