Tripp-Lite B024-DUA8-SL Manual Del Propietário página 36

Basic Operation
4. Access the OSD as an Administrator, and navigate to the F4 ADM menu. Select
the Firmware Upgrade option from the list, and type [Y] to initiate Firmware
Upgrade mode.
5. On the computer where the firmware upgrade file is saved, run the Firmware
Upgrade Utility file by double-clicking on it or by opening up a command line and
typing the path.
6. After reading the license agreement, click on the I Agree option, then click Next.
The Firmware Upgrade Utility main screen appears and displays the KVM switch
in the Device List on the left side of the screen.
7. Highlight the KVM switch in the Device List by clicking on it. For the Firmware
Upgrade Utility to check the KVM's firmware version and determine if it is older/
newer than the firmware upgrade file, check the Check Firmware Version box in
the lower-left of the screen. If you want the Firmware Upgrade Utility to upload
the firmware upgrade file without checking the KVM's firmware version, leave this
box unchecked. Click Next.
8. If the Check Firmware Version box is checked and the Firmware Upgrade Utility
finds the KVM's firmware is newer than that of the firmware upgrade file, a
prompt to continue or cancel will display. Once the firmware upgrade starts,
status messages appear in the Status Message panel and progress towards
completion is shown in the Progress Bar. When the upgrade is complete, the
Status Message panel will inform you that the firmware upgrade was successful.
Click Finish to complete the firmware upgrade. After a successful firmware
upgrade, the switch will reset itself.
Firmware Upgrade Failure
If you are not notified of a successful firmware upgrade, then the firmware upgrade
failed to install properly. In this case, perform the following steps:
1. Power off the KVM switch by disconnecting the external power supply.
2. Connect the firmware upgrade cable to the KVM's firmware upgrade port.
3. Slide the Firmware Upgrade Recovery switch located on the front of the KVM to
the Recover position.
4. Power the switch back on and perform the firmware upgrade again.
5. After the switch has been successfully upgraded, power it off, then slide the
firmware recovery switch to Normal.
6. Power the switch back on.
17-10-479-93370A.indb 36
36
11/17/2017 2:29:04 PM