Tripp-Lite B024-DUA8-SL Manual Del Propietário página 15

Installation
3
Connect a monitor to the first level KVM switch using one of the following three
methods.
a. DVI Monitor – Connect the DVI port on the monitor to the DVI-I console port
located on the rear of the KVM switch.
b. DVI + VGA Monitor – For monitors with DVI and VGA ports, you can connect
both to the KVM switch. Connect the DVI port on the monitor to the KVM's
DVI-I console port, and the VGA port on the monitor to the KVM's VGA console
port.
c. DVI and VGA Monitors – Connect a DVI monitor to the DVI-I console port on
the KVM, and a VGA monitor to the VGA console port.
Note: Only one video signal will transmit at a time. When connecting to both the DVI and
VGA ports on a single monitor, or when connecting DVI and VGA monitors at the same
time, the video output used will be determined by the OSD settings. See the Set Computer
Video Input section in this manual for details.
4
Repeat step 3 for each KVM in the installation.
Note: The OSD setting of the first level KVM switch determines the video output used by
each KVM in the installation.
5
Connect a USB keyboard and mouse to the corresponding USB keyboard and
mouse console ports located on the back of the first level KVM switch.
Note: This step is required for the first level KVM switch only.
6
Optional – Connect a microphone and speakers to the corresponding 3.5 mm
console jacks on the unit's front or rear panel. The front panel jacks will take
priority over those on the rear panel.
Note: This step is required for the level one KVM switch only.
7
Optional – Connect USB device(s) to the USB 2.0 hub port(s) on the front and
rear of the KVM switch.
Note: This step is required for the level one KVM switch only.
8
Connect the KVM cable kit to the KVM switch. The USB-B male connector side
plugs in to an available set of computer ports located on the rear panel of the first
level KVM switch. Connect the DVI-D connector to the DVI-I port, and the USB
and 3.5 mm connectors to its corresponding USB and 3.5 mm ports.
Note: KVMs include two 6 ft. cable kits. For the remaining ports requiring cables, or if a
longer cable is needed, separate P759-Series DVI/USB + Audio KVM Cable Kits are need
(sold separately).
9
Connect the other end of the KVM cable kit to the corresponding ports on the
computer you wish to add to the installation.
10
From the same computer port on the second level KVM switch that was just used
to connect a computer to the first level KVM switch, connect the DVI-I port to the
second DVI port of the same computer with a DVI cable (such as Tripp Lite P560-
and P561-Series cables).
17-10-479-93370A.indb 15
15
11/17/2017 2:29:01 PM