Balanced Body Combinación Reformer Trapecio Manual Del Usuario página 8

Risers
ASSEMBLE THE TRAPEZE CANOPY
1. Using the provided 3/16" allen wrench, loosen the set screws
in each of the eight flange connectors mounted to the outside
of the frame. Remove the two vertical tubes from the box and
the sliding push thru bar system. Lay the tubes down so the
holes on the sides of the tubes face away from each other.
Take the sliders of the push thru bar (PTB) and slide them
over the tubes opposite the end with the eye bolts, you will
need to pull the knobs of the sliders out to move the sliders
up the tubes. Continue to move the sliders up the tubes
until the pins lock into the bottom set of the three holes in
the tube. Make sure both sliders are locked into the same
bottom holes. Insert the provided cotter pins into each of
the 1/8" holes near the bottom ends of the tube. Pick up this
assembled tube set, be careful of the PTB, it may swing; place
the assembly in the flanges on the head end of the machine
(the end with the vinyl flaps). Be carefully of the cotter pins so
they do not scratch the vinyl or wooden frame. The cotter pins
will automatically set the tubing height.
6
Shoulder
Rests h
Footbar b
Reformer Mode
2. Insert the provided cotter pins into each of the 1/8" holes near
the bottom ends of the other two vertical tubes. Pick up the
tube assembly with the vertical slider and place the tube ends
into the flanges on the foot end of the frame.
3. Now set the canopy top onto the four vertical tubes. You will
need help with this. The end of the canopy frame with the
black safety strap goes over the push-through bar. Be certain
all four corner fittings fit securely over the tubes.
4. Using the 3/16" allen wrench, tighten the set screws in the
corner fittings and in the flanges around the frame. After
tightening all set screws in all the corner angles, test the
movement of the sliding push thru bar. To do this pull the
knobs of the sliders out and start sliding the PTB up or down.
This system should move easily and not stick when uniform
pressure is applied on each side. If the sliders stick when
moving the position, simply loosen the set screws that are
holding the vertical poles, rotate the tubes as necessary until
the sliders move freely. Be sure to re-tighten all set screws.
Remove the cotter pins from the tubes and save for future
use.