Descargar Imprimir esta página

BH H673 Manual De Instrucciones página 7

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
4. Begin the exercise and the distance
value will begin the countdown, when
it reaches zero it will beep for 4
seconds,
advising
selected distance has been covered,
the distance value will then start
counting upward.
D. CALORIE FUNCTION.-
This function counts up or down in
steps of 1 calorie, up to a maximum of
999 calories.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small CALORIES window flashing.
3. Press the SET key to select the
calories.
4. Begin the exercise and the calorie
value will begin the countdown, when
it reaches zero it will beep for 4
seconds,
advising
selected
calorie
reached, the calorie value will then
start counting upward.
E.
HAND-GRIP
INSTRUCTIONS / USE.-
On this model the pulse rate is
measured by placing both hands on
the sensors (R), located on the
handlebar, Fig. 3.
When both hands are placed on the
sensors the heart symbol on the right-
hand side of the screen, marked
PULSE, will begin to flash and after a
few seconds a heart rate reading will
be displayed.
If both hands are not placed correctly
as shown in Fig. 3 then the pulse
function will not work.
If a "P" appears on the screen or the
heart symbol does not flash then
make sure that both hands are placed
on
the
sensors
you
that
the
you
that
the
value
has
been
(PULSE)
and
that
the
connectors are connected at the back
of the electronic unit.
TROUBLESHOOTING GUIDE.-
Problem: The display comes on but
only the Time function works
Solution:
a.- Make sure that the connection
cable is connected.
Problem: The display does not come
on or the displayed segments are very
weak.
Solution:
a.- Check that the batteries are fitted
correctly.
b.- Check the battery charge.
c.- If they are run down change them
immediately.
Problem: Display segments of a
function read-out are not visible or
error
messages
function appear.
Solution:
a.- Remove the batteries for 15
seconds and then refit them correctly.
b.- Check the battery charge If they
are run down change the batteries
c.- If the above steps do not help then
replace the electronic monitor.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
7
for
a
particular

Publicidad

loading