Safety Precautions - Look R38D Manual De Instrucciones

!
Before riding your bicycle :
• Check that the threads of your thru axles are
greased to ensure optimal tightening - refer to the
manufacturer's instructions (axle or frame).
Check that your thru axles are properly tightened
according to the bike manufacturer's torque
specifications.
• Check the pressure and condition of your tires,
ensuring that the inflation pressure is suitable for the
type of tire and wheel(s) you are using.
• Check your rims for damage.
• Check that the spokes are in good condition, and
that they are not damaged or slack.
• Check that your brake rotors are correctly secured
to the hubs and are not greasy or bent.

SAFETY PRECAUTIONS

!
• Do not remove the stickers on the rim listing the
use and safety instructions.
• Follow the regular maintenance guidelines.
• Only use original LOOK or DT SWISS spare parts.
• Do not perform any work or alterations on your
wheels such as drilling, sanding etc...
• Any parts damaged as a result of impacts or
accidents must be replaced by LOOK or DT SWISS
spare parts, not repaired.
• Braking distances are increased in rainy conditions
or on wet roads. Please bear this in mind and
anticipate your braking accordingly!
• In case of a puncture, stop immediately to avoid
riding with a flat tire and damaging the carbon rim.
• The combined weight of the cyclist and bike must
not exceed 100 kg.
If any suspicious or abnormal noise should appear,
stop immediately and inspect your bike.
• LOOK CYCLE recommends that you wear an
approved protective helmet and that you comply
with the traffic laws of the country in which you are
riding.
General instructions
EN
19