GLOBBER ONE K E-MOTION 10 Manual Del Usuario página 3

Keep the instructions for future since it contains important information.
NF EN 71
READ THE INSTRUCTIONS PROVIDED BY THE MANUFACTURER BEFORE USING.
Warning! Not suitable for children under 36 months, unstable base, fall hazard. Warning! Protective
equipment should be worn. Not to be used in traffic. 50 kg max.
Warning! This toy is unsuitable for children under 6 years due to its maximum speed.
This warning cited from EN71-1 cannot be altered for legal purposes and the correct age range to
follow is stated on the front of the IM and packaging box.
Remove the scooter and all the parts from the box. Set out all the parts and read the assembly
instructions prior to use. Keep the packaging until assembly is complete.
1 - GENERAL INSTRUCTIONS
This toy must be assembled by a responsible adult. Prior to use, make sure that the toy has been
assembled properly. Remove all the parts which are not necessary for playing before giving the toy
to your child. The toy should be used with caution since skill is required to avoid falls or collisions
causing injury to the user or third parties.
To use with suitable protective equipment, including a helmet, shoes, elbow, wrist and knee
protectors. Teach the child how to use it safely and responsibly.
- The scooter is not a toy for children under the age of 3 years.
- The toy shall only be used with charger for toys.
- The model charger no. JY15-240-060 is suitable for use with the toy.
- The charger is not a toy.
- Misuse of charger can cause electrical shock.
- Toy liable to be cleaned with liquids are to be disconnected from the charger before cleaning.
- Never use the product close to a water source. Stop using the product when damaged.
DIRECTIONS:
Warning! Using the toy in areas other than private grounds can be dangerous, using on public
roads can lead to traffic accidents.
- The scooter can be dangerous and can cause traffic accidents when used on public highways.
Don't use on public roads. It is best used on a flat, clean surface, free of gravel and grease. Avoid
bumps and drainage grates that may cause an accident.
- Always use under adult supervision.
- Do not allow more than one child to ride the scooter at the same time.
- Do not use on wet days, or on wet ground.
BEFORE AND AFTER USE:
Make sure that all locking mechanisms are securely locked:
- Check the height of the steering system, and make sure the nuts are tightened and that the
handlebars and the front wheel are perpendicular.
- The minimum height of the T-bar has to be locked at the lowest position by switching the bullet
into the lowest slot.
- Check all of the connection elements: the brake, the steering column's quick release system and
the wheel axles must be adjusted correctly and not damaged.
4
- Also check the tyre wear.
2 - TECHNICAL SPECIFICATION
Material Steel, aluminium, polypropylene
Assembled Scooter Size
L 83 x W 49.5 x H 91cm
Weight 5.8 kg
Minimum user height / 1.2m
Maximum weight 50 kg
Maximum Speed 12 km/h
Maximum range per charge
8 km*
Operating temperature 0°C - 40°C
Motor Power
150 W
Front Wheel Size 5.5" (140mm)
Rear Wheel Size 5" (128mm)
Battery Capacity (Ah)
2,6Ah
21.6 V (End-of-discharge voltage : 18 V -
Battery voltage
Upper limit of the charging voltage : 25.2 V)
AC input 100-240v 50/60HZ
Charger
DC output 24 V 0.6 A
Charging time 3-4 Hours
Sealing around compartment
IPX4
*depending on the user's weight.
Original instructions
3 - ASSEMBLY
1. Insert the steering column into the threaded axle, do not tighten the clamp at this stage.
2. Place the handlebar in the housing at the top of the steering column and secure the clamp with
the two screws.
3. Align the handlebars with the wheel axle, then tighten the clamp at the bottom of the threaded
axle.
1 2 3
4 - MODE OF OPERATION AND USE
ON/OFF FUNCTION
- This scooter has a Kick Start function.
- To start, push your scooter forward. The battery lights signal on the deck will turn on; you are
now in the "ON" mode.
- Your E10 will turn off automatically after 1 minute of inactivity; the battery lights signal will also
go off.
START-UP
- You are in a position to start:
To engage the motor, 2 actions are necessary.
Place your foot directly on the accelerator pressure sensor.
Push your scooter to reach a speed of 5km/h.
Be aware that once your motor is turned ON, reducing your speed below 5km/h does not
automatically cut the motor, see paragraph STOP regarding the instructions for stopping the
motor permanently.
CHECK SPEED
To control the speed, you can simultaneously OR independently use the brake located at the rear
of the scooter (mudguard) or/and use acceleration sensor located on the top of the deck (Press
with your foot to accelerate, remove your foot to slowdown)
- Once the electric motor is engaged, it will accelerate until reaching the cruising speed of 12
km/h.
- You can control the speed with the electronic brake located at the rear: pressing this brake
automatically stops the motor. This system generates both mechanical and electrical braking
that reduce again the braking distance.
- WARNING! Engaging the brake (mudguard) automatically shuts off the motor and only until you
press the brake. If you release the brake, the motor automatically engages again.
STOP
To stop the motor completely, press the brake continuously for 3 seconds and wait for the scooter
to stop safely to get off the platform. The lights at the rear brake will also light up when engaging.
At any time you can remove your foot from the acceleration sensor to automatically shut down
the motor for example in an emergency. The battery will automatically turn itself off when the
motor is not engaged for more than 60 seconds.
5 - CHARGING
Before charging, please read the following instructions:
- This appliance can be used by children aged 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and under the
hazards involved.
- Children shall not play the appliance.
- Cleaning and user maintenance should not be made by children without supervision.
- The charger is specific for lithium battery pack 21.6V and 2.6AH (Model No.:
6S1PSCOOTERM26).
- The battery charger has LED indicator: GREEN light indicates the battery is fully charged or
disconnected; RED light indicates the battery is in charging.
- Batteries are only to be charged by adults or by children at least 8 years old.
- Batteries are to be inserted with the correct polarity.
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
- Do not recharge non-rechargeable batteries. It may cause explosion.
- Battery chargers used with the toy should be regularly examined for damage to the cord, plug,
enclosure and other parts.
- In the event of such damage, they must not be used until the damage has been repaired.
- Only use the charger supplied with your electric scooter. Using a charger other than that
supplied will invalidate the warranty.
- To optimise the performances and lifetime of your electric scooter battery, fully charge the
battery before using it for the first time and fully charge it once a month.
- Do not cover the battery compartment or the charger. There must be good ventilation conditions
at all times during charging.
- The charging environment must be clean. Ensure there are no traces of damp or water in the
electric socket before plugging in.
- Ensure you use a standard socket.
- Do not switch on the scooter during charging.
Warning. Do not use the battery or the device in the following cases:
1. The battery gives off a smell or the temperature inside the appliance is too high.
2. Leaks on the deck of the scooter.
If in doubt please contact Globber, contact@globber.com
When the battery signal light on the deck becomes low, you can
recharge the battery with the specific charger.
Your electric scooter is delivered with a specific charger.
1. To charge your electric scooter, remove the waterproof cap from the port and plug in the
charger. For safety reasons, ensure the charging port is always dry before starting to charge.
2. Plug the charger into a suitable power source.
3. When LED on the charger is red, the battery is charging.
4. When it switches to green, charging is complete. This takes approximately 3 hours. Stop
charging when the LED turns green; charging the battery for too long will reduce its lifetime.
1 2 3 4
5