Playback
■ Adjusting the BASS and TREBLE
controls
DIMMER
DISPLAY
MODE
INPUT
BASS
PHONES
SPEAKERS
A
B
5V
1A
BASS
The BASS and TREBLE controls adjust high and low
frequency response.
The center position produces a flat response.
BASS control
When you feel there is not enough bass (low frequency
sound), rotate clockwise to boost. When you feel there is
too much bass, rotate counterclockwise to suppress.
Control range: –10 dB to +10 dB (20 Hz)
TREBLE control
When you feel there is not enough treble (high frequency
sound), rotate clockwise to boost. When you feel there is
too much treble, rotate counterclockwise to suppress.
Control range: –10 dB to +10 dB (20 kHz)
■ Adjusting the BALANCE control
DIMMER
DISPLAY
MODE
INPUT
BASS
PHONES
SPEAKERS
A
B
5V
1A
The BALANCE control adjusts the sound output balance
of the left and right speakers to compensate for sound
imbalance caused by speaker locations or listening room
conditions.
22
En
PURE DIRECT
MEMORY
CLEAR
BAND
PRESET
TUNING
VOLUME
TREBLE
BALANCE
LOUDNESS
SELECT
PUSH - ENTER
FLAT
-30dB
RETURN
CONNECT
L
R
TREBLE
PURE DIRECT
MEMORY
CLEAR
BAND
PRESET
TUNING
VOLUME
TREBLE
BALANCE
LOUDNESS
SELECT
PUSH - ENTER
FLAT
-30dB
RETURN
CONNECT
L
R
BALANCE
■ Adjusting the LOUDNESS control
DIMMER
DISPLAY
MODE
INPUT
BASS
PHONES
SPEAKERS
A
B
5V
1A
HOME
SETUP
NOW PLAYING
Retain a full tonal range at any volume level, thus
compensating for the human ears' loss of sensitivity to
high and low-frequency ranges at low volume.
CAUTION
If the PURE DIRECT switch is turned on with the
LOUDNESS control set at a certain level, the input signals
bypass the LOUDNESS control, resulting in a sudden
increase in the sound output level. To prevent your ears or
the speakers from being damaged, be sure to press the
PURE DIRECT switch after lowering the sound output
level or after checking that the LOUDNESS control is
properly set.
1
Set the LOUDNESS control to the FLAT
position.
2
Rotate the VOLUME control on the front
panel (or press VOLUME +/– on the remote
control) to set the sound output level to the
loudest listening level that you would listen
to.
3
Rotate the LOUDNESS control until the
desired volume is obtained.
y
After setting the LOUDNESS control, enjoy listening to music at
your preferred volume level. If the effect of the LOUDNESS
control setting is too strong or weak, readjust the LOUDNESS
control.
PURE DIRECT
MEMORY
CLEAR
BAND
PRESET
TUNING
VOLUME
TREBLE
BALANCE
LOUDNESS
SELECT
PUSH - ENTER
FLAT
-30dB
RETURN
CONNECT
L
R
LOUDNESS
VOLUME
RETURN
OPTION
VOLUME +/–
VOLUME
MUTE