Reloading The Magazine - Prebena PKT-2-ES40-S Manual Del Usuario

Operating the pneumatic tool
Releasing the pneumatic tool
Proceed as follows to release the pneumatic tool:
Press the nose of the tool onto the piece of wood.
Pull the trigger all the way through.
A fastener will be driven into the piece of wood.
Release the trigger.
Lift the pneumatic tool off of the piece of wood.
Repeat these steps to drive-in another fastener.

Reloading the magazine

Fill the magazine as described on page 21.
The PKT-2-CLIP45-SY pneumatic tool is equipped with a lock-out
safety device. The lock-out safety device is activated when there are
no more fasteners in the magazine. If the lock-out safety device is
activated you will be unable to release the pneumatic tool. You will
not be able to drive-in any other fasteners.
In this case fill the magazine as described starting on page 21.
34
WARNING
The most serious injuries are possible when
operating the pneumatic tool with defective or
bypassed safety device.
Only use the pneumatic tool if the safety
device is functional.
Only release the pneumatic tool when the
nose of the tool is firmly pressed against
the material.