Switching The Aux Mode On And Off - Eclipse CD5030 Manual Del Usuario

How to listen to a music using a portable audio player
English
Connecting a portable audio player to the AUX jack
Use a commonly available accessory cable with an RCA connector or an optional AUX105 to
connect a portable audio player to the AUX (auxiliary) jack of this system.
There are 2 connection terminals on this main unit; one for the RCA connector and the other for the optional
LAN cable (AUX 105). The default setting for AUX is OFF.
Turn on the portable audio player and start its play function.
1
If AUX is set to "ON" in function mode , AUX will be activated.
For details, refer to "Switching Audio Modes" on page 4.
ATTENTION
• While the AUX mode is activated, actions such as turning off the audio player or pulling out the connection cord may
cause noise spikes that can damage the system speakers. Be sure to avoid this possibility by turning off system
power or switching from the AUX mode to another mode before shutting off or disconnecting the portable audio
player.
• Audio output levels for the various devices that can be connected using this method will differ. Carefully adjust the
volume until the output level of the connected player is known.
• Before using a portable audio player in a vehicle, read the player's operation manual carefully and confi rm problem-
free operation in the vehicle before proceeding.
• When you connect an optional LAN cable (AUX 105) to the main unit, other optional equipment that uses E-LAN
cannot be connected.

Switching the AUX mode on and off

Press the [ /MENU] button for
1
more than one second.
The Menu selection mode is activated.
2 Press the [▲] button or the [▼]
button to select FUNC ,and then
press the [ENTER] button.
The function mode is activated.
Press the [▲] button or the [▼]
3
button to select AUX ON/OFF, and
then press the [ENTER] button.
The AUX ON/OFF mode is activated.
4 Press the [▲] button or the [▼]
button to select the ON/OFF mode,
and then press the [ENTER] button.
Press the button to switch the mode as follows:
[▲] :
Mode is ON
[▼] :
Mode is OFF
The selected settings will take effect.
15