Diagram - Segway Loomo Manual Del Usuario

2.

Diagram

LCD Screen
Mic Array
Headlight
Infrared Sensors
Power Button
Tire Air Tap
Power Button
Lock
Speed Limit
Power Level
Status Display Panel
02
HD Camera
Intel RealSense
Ultrasonic Sensor
Power Indicator
Charger Port
Wheel Lights
Press and hold the power button to turn Loomo ON/OFF.
Indicates whether Loomo' s base is locked or not.
Indicates whether Loomo is in Speed Limit mode or not.
Indicates the remaining battery life. Each block equates to
approximately 20% of battery. When the battery is nearly
empty, this icon blinks, indicating you should charge Loomo.
When the power level is below 10%, the speed will be limited
to 6.2 mph (10 km/h).
Left Touchpad
Speaker
Transform Button
Press to switch Loomo between robot and self-balancing vehicle (SBV) mode.
Side (Left/Right) Touchpads
Tap the side touchpads to restore Loomo to its default state.
Hand Touch-Bar
Hold the hand touch-bar to move Loomo in either robot or SBV mode.
Touch and hold the inner button inside the handle to stop Loomo's engine temporarily
Lifting Handle
to lift or carry Loomo safely.
Hand Touch-Bar
Transform Button
USB Type-C
Lifting Handle
Extension Bay
Taillights
03