Connect Ductwork - Broan beat K34 Manual De Usario

CONNECT DUCTWORK

Ducted Configuration
1. Use screws (4.8x38mm) and wall anchors
(supplied) to secure flue mounting bracket
to the ceiling or wall as shown.
2. Use 6" round metal duct to connect the duct
collar on the hood to the ductwork above.
3. Use duct tape to make all joints secure and
air tight.
4. Connect the decorative flue to the bracket
with 2 screws provided (3.9x9.5mm).
5. Slide the lower flue downward, until it fits
properly around hood.
6. Secure decorative flue to hood with 4 screws
provided (3.9x9.5mm).
FASTEN
FLUE TO
HOOD
WITH
SCREWS
(3.9x9.5mm)
MOUNTING SCREWS
(4.8x38mm)
- 7 -
FLUE MOUNTING
BRACKET
FASTEN
FLUE TO
BRACKET
WITH
SCREWS
(3.9x9.5mm)
DECORATIVE
FLUE
DUCT TAPE
AIR VENT
POSITION FOR
DUCTED
CONFIGURATION
6" ROUND
METAL DUCT