Connect Ductwork - Broan best IEX42 Manual De Instrucciones

CONNECT DUCTWORK

1. Use 8" round metal duct to connect the
discharge collar on the hood to the ductwork
above.
2. Use duct tape to make all joints secure and
air tight.
3. Remove the two temporary retaining
screws from the lower flue and set it in place
on the hood.
4. Secure decorative flue to hood with two
mounting screws (3,9x9,5mm).
BOTTOM TRIM
REPLACEMENT
1. Remove the four (4) screws from the inside
of the hood.
2. Remove the trim by pulling downward.
3. Slide the new trim upward onto hood.
4. Replace the four screws removed in step
1 above.
All manuals and user guides at all-guides.com
- 11 -
LOWER FLUE
8" ROUND METAL
DUCT
RETAINING
SCREWS
MOUNTING
SCREWS
(3.9X9.5MM)