Connect Ductwork - Broan best ISER222 Manual Del Usuario

Ocultar thumbs Ver también para best ISER222:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CONNECT DUCTWORK

1. Use 8" round metal duct to connect the
duct collar on the hood to the ductwork
above.
2. Use duct tape to make all joints secure and
air tight.
3. Slide the lower decorative flue section
downward, until it fits properly around hood.
4. Secure decorative flue to hood with screws
provided.
MAINTENANCE
Grease Filters
The grease filters should be cleaned fre-
quently. Use a warm detergent solution. Grease
filters are dishwasher safe.
To take off the grease filters: at the handle, push
the stop inwards and pull the filters downwards.
Hood Cleaning
Stainless steel is one of the easiest materials
to keep clean. Occasional care will help preserve its fine appearance.
Cleaning tips:
Hot water with soap or detergent is all that is usually needed.
Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth to
avoid water marks.
For discolorations or deposits that persist, use a non-scratching household cleanser
or stainless steel polishing powder with a little water and a soft cloth.
For stubborn cases, use a plastic scouring pad or soft bristle brush together with
cleaser and water. Rub lightly in direction of polishing lines or "grain" of the
stainless finish. Avoid using too much pressure which may mar the surface.
DO NOT allow deposits to remain for long periods of time.
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere
to the surface causing rust.
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to
remain in contact with stainless steel for extended periods. Many of these com-
pounds contain chemicals which may be harmful. Rinse with water after expo-
sure and wipe dry with a clean cloth.
Painted surfaces should be cleaned with warm water and mild detergent only.
OPERATION
Controls
The hood is operated using the (5) push-but-
tons located at eye-level, on the front edge of
the hood.
The light switch turns the halogen lights on
and off.
The blower on-off / speed 1 switch turns the
blower on to its lowest running speed. Turn
LOWER
DECORATIVE
FLUE
SECTION
LIGHT
SWITCH
BLOWER
ON-OFF /
SPEED 1
0-1
- 5 -
8" ROUND
METAL
DUCT
GREASE FILTERS
BLOWER
SPEED 2
BLOWER
SPEED 3
BLOWER
SPEED 4
LED
LED
LED
4
2
3
LED

Publicidad

Tabla de contenido
loading

Tabla de contenido