Evolution F165 CCSL Instrucciones Originales página 4

VIBRATION
Note: The vibration measurement was made
(1.5)
under standard conditions in accordance with:
EN 62841-1: 2015,
EN 62841-2-5: 2014
Warning: Wear hearing protection!
The declared vibration total value has been
measured in accordance with a standard test
method and may be used for comparing one tool
with another.
The declared vibration total value may also be
used in a preliminary assessment of exposure.
WARNING: When using this machine
(1.6)
the operator can be exposed to high levels of
vibration transmitted to the hand and arm.
It is possible that the operator could develop
"Vibration white finger disease" (Raynaud
syndrome). This condition can reduce the
sensitivity of the hand to temperature as
well as producing general numbness.
Prolonged or regular users of this machine
should monitor the condition of their hands and
fingers closely. If any of the symptoms become
evident, seek immediate
medical advice.
• The measurement and assessment of human
exposure to hand-transmitted vibration in the
workplace is given in:
EN 62841-1 and EN 62841-2-5
• Many factors can influence the actual
vibration level during operation e.g. the work
surfaces condition and orientation and the
type and condition of the machine being
used. Before each use, such factors should
be assessed, and where possible appropriate
working practices adopted. Managing these
factors can help reduce
the effects of vibration:
Handling
• Handle the machine with care,
allowing the machine to do the work.
• Avoid using excessive physical effort on any of
the machines controls.
• Consider your security and stability, and the
orientation of the machine during use.
Work Surface
• Consider the work surface material;
its condition, density, strength,
rigidity and orientation.
WARNING: The vibration emission during
actual use of the power tool can differ from the
declared total value depending on the ways in
which the tool is used.
www.evolutionpowertools.com
The need to identify safety measures and to
protect the operator are based on an estimation
of exposure in the actual conditions of use
(taking account of all parts
of the operating cycle, such as the times the tool
is switched off, when it is running idle,
in addition to trigger time).
LABELS & SYMBOLS
(1.7 )
WARNING: Do not operate this machine
if warning and/or instruction labels are missing
or damaged. Contact Evolution
Power Tools for replacement labels.
Note: All or some of the following symbols may
appear in the manual or on the product.
(1.8)
Symbol
V
A
Hz
Min / RPM
-1
~
Alternating Current
n o
Wear Safety Goggles
Wear Ear Protection
Wear Dust Protection
Electronic Equipment
4
Description
Volts
Amperes
Hertz
Speed
No Load Speed
Read Instructions
Double Insulated
CE Certification
ETL Certification
Waste Electrical &