Operation - EINHELL GE-CM 18/30 Li - Solo Manual De Instrucciones Original

charger (17).
4. In the section entitled „Charger indicator" you
will Þ nd a table with an explanation of the LED
indicator on the charger.
The battery pack can become a little warm during
the charging. This is normal.
If the battery pack fails to charge, check:
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging
contacts
If the battery pack still fails to charge, send
•
the charging unit
•
and the battery pack
to our customer service center.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
Battery capacity indicator (Fig. 7)
Press the switch for the battery capacity indicator
(Item A). The battery capacity indicator (Item B)
shows the charge status of the battery using 3
LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED ß ashes:
The battery is empty, recharge the battery.
All LEDs ß ash:
The battery pack has undergone exhaustive
discharge and is defective. Do not use or charge a
defective battery pack.
Mounting the charging unit on a wall (Fig. 13)
The charging unit can also be mounted on a wall.
The correct dimensions for drilling holes in the
wall can be found on the back of the charging unit.
Spacing distances
10 cm from the wall (right + left)
100 cm from the ceiling
Caution!
Anl_SA_GE_CM_18_30_Li_Solo_ARG.indb 28
GB
When mounting on a wall you must use suitable
screws, e.g. 3.5 mm pan-head screws, in order to
prevent damage to the housing and risk of falling.
Installing the battery (Fig. 8)
•
Open the battery cover.
•
Insert the battery pack in the mount.
•
Close the battery cover by flipping the cover
down

6. Operation

Caution!
The lawn mover is equipped with a safety circuit to
prevent unauthorized use. Directly before starting
up the lawn mover insert the safety plug (Fig. 9)
and remove the safety plug again whenever you
interrupt or terminate your work.
Caution!
To prevent the equipment switching on acciden-
tally, the lawn mower is equipped with a safety
switch (Fig. 10/Item 8) which must be pressed
before the switching bar (Fig. 10/Item 1) can be
activated. The lawn mower switches itself o when
the switching bar is released. The start time can
amount to several seconds. The speed will drop
after a few seconds when in idle mode and will
rise again after a few second when in working
mode. The lawn mower switches itself o when
the switching bar is released. Repeat this process
several times so that you are sure that the ma-
chine functions properly. Before you perform any
repair or maintenance work on the equipment,
ensure that the blade is not rotating and that the
power supply is disconnected (Fig. 9).
Caution! Never open the chute ß ap when the
grass bag has been detached (to be emptied)
and the motor is still running. A rotating blade
can cause serious injuries!
Always carefully fasten the chute ß ap and grass
basket. Switch o the engine before emptying the
grass basket.
Always ensure that a safe distance (provided
by the length of the long handles) is maintained
between the user and the mower housing. Be
especially careful when mowing and changing
direction on slopes and inclines. Maintain a solid
footing and wear sturdy, non-slip footwear and
long trousers.
- 28 -
24.07.2018 09:28:50